hopefully I'll do
untick everything in every tab, in top right corner there is a drop down which should allow you to save a profile, call it blank.
then go and tick your boxes and save it as something else such as malware pre-clean or general maintenance, etc. this will be your profile.
to start off you may find it easier to create several profiles that are ran 'per' Tab, E. G. use the start auto button on the tab pages. I never run "full auto" from the top right as I find it logistically complicated, I find it easier to complete work in stages, each stage represents each tab needed for example.
the joy of d7ii isn't necessarily the automation of work, it's the routines it creates for you in the "road-map" of any repair. knowing and implementing a trusted routine for a typical malware cleanup is where d7ii helps.. alot. it also means if another engineer continues the work for any reason, they know the same routine so can follow it through giving some consistency for the job itself.
Sent from my ForwardXtreme using Tapatalk
I can walk on water, but I can’t perform miracles.